30
Special Set-Up Procedure (Continued)
Tape Leg Length
Changing Tape Leg Length From 70 to 50 mm [2-3/4
to 2 inches].
1. Use care when working near tape cut-
off knife as knife is extremely sharp. If
care is not taken, severe injury could
occur.
2. When removing the upper taping head
mounting screws, support or hold the
taping head to prevent it from falling.
3. Taping head weighs approximately
7.32 kg [16 lbs]. Use proper lifting
techniques when removing or installing
taping head.
1. Remove taping heads from machine.
Upper taping head remove and retain four
mounting screws as shown in Figure 5-2 and
remove taping head.
Lower Taping head raise and latch upper taping
head frame in its full "Up" position.
Turn air supply "Off" at on/off valve.
Lift lower taping head straight up to remove from
machine bed.
2. Refer to Section II, page 13, "Tape Leg Length
Changing Tape Leg Length from 70 to 50 mm
[2-3/4 to 2 inches]".
3. Install taping heads in machine reverse of
disassembly.
WARNINGS
Figure 5-2 Upper Taping Head, Removal
To Next Page
Loading...
