NA - ENG
April 2016
3M-Matic
™
8000a-8000a3
Page 18
Figure 7-2
Figure 7-1
Figure 7-3
7.1 Operating Conditions
The machine should operate in a
dry and relatively clean environment
(See Speci cations).
7.2 Space Requirements for
Machine Operation and
Maintenance Work
Minimum distance from wall
(Figure 7-1):
A = 1000mm.
B = 700mm.
Minimum height = 2700mm.
7.3 Tool Kit Supplied with Machine
A tool kit containing some tools are
supplied with the machine. These
tools should be adequate to set-up
the machine, however, other tools
supplied by the customer will be
required for machine maintenance.
7.4 Machine Set-Up / Bed Height
1 - Lift the machine with belts or
ropes paying attention to place
belts in the points (Figure 7-2).
To set the machine bed height,
do the following:
2 - Adjust machine bed height.
The case sealer is equipped
with four (4) adjustable legs
that are located at the corners
of the machine frame.
The legs can be adjusted to
obtain di erent machine bed
heights (Figure 7-3).
Also refer to “Speci cations”
3 - Lock the screws.
4 - Repeat the operation for all legs.
(It is not necessary to x or
anchor the machine to the oor).
5 - For Outer Column Positioning -
The columns are shipped in a
lower position.
To Adjust Columns - See Special
Set-up Procedure (Section 11) .
7. Installation
B
A
To Next Page
Loading...
