NA - ENG
April 2016
3M-Matic
™
8000a-8000a3
Page 19
7.5 Removal of Plastic TIes
Cut the plastic which attaches the
top head to the frame and remove
the polystyrene blocks (Figure 7-4).
Cut the plastic strap which
attaches the strip and the
EMERGENCY STOP cable to the
frame
(Figure 7-5).
Cut the plastic
ties holding the lower taping head
in position
(Figure 7-6).
7.6 Assembly Completion
1. Handle - Remove handle from
shipping position and reinstall
in operational position -
(Figure 7-7A).
2. Tape Drum Bracket - Install upper
tape drum bracket on top cross
bar as shown (Figure 7-7B).
Figure 7-5
Figure 7-6
Figure 7-4
7. Installation (continued)
Figure 7-7
B
C
A
To Next Page
Loading...
