3M CP45 - Sensitivity Calibration; Keypad Sensitivity

5
English
1
Power on the Camcorder Projector.
2
Press the Menu button ( ), and then press the Left/Right ( / ) arrows to
navigate to Setting Screen ( ).
3
Press the Up/Down ( / ) arrows to navigate to the Sensitivity Calibration
item.
4
Press the OK button to enable the calibration process.
5
The screen will show “Calibration Start”. Do not touch the Camcorder Projector
during the calibration process.
6
The screen will show “OK” after calibration is complete. Touch any key to close
the message.
Sensitivity Calibration
1
Press the Menu button ( ), and then press the Left/Right ( / ) arrows to
navigate to Setting Screen ( ).
2
Press the Up/Down ( / ) arrows to navigate to the Keypad Sensitivity item,
and then press the OK button to conrm.
3
Use the Up/Down ( / ) arrows to adjust the Keypad Sensitivity to desire
setting from -2, -1, 0, +1 and +2 selections.
4
Press the OK button to enable the adjustment process.
Keypad Sensitivity
© 3M 2011. All Rights Reserved.
3M™ Camcorder Projector CP45