EasyManua.ls Logo

3M DBI-SALA Delta - Page 18

3M DBI-SALA Delta
36 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18
7.0 LABELING:
Figure 18 illustrates product labels on the Delta Full Body Harness. All labeling must be present and fully legible.
Information on each label is as follows:
1
Size label.
2
ANSI Warning label: Warning: Manufacturers instructions must be read and understood prior to use. Instructions
supplied with this product at time of shipment must be followed. Failure to do so could result in serious injury or death.
Contact Capital Safety if instruction sheet is needed. Inspect before each use. Do not use if wear or damage is present.
This body harness is intended to be used to arrest the most severe free falls. Items subjected to fall arrest or impact
forces must be immediately removed from service and destroyed. Connecting snap and D-ring must be compatible
in size, shape and strength. This item is not ame or heat resistant. Repairs only to be performed by Capital Safety.
Equipment modication or misuse voids warranty.
Do not exceed capacity of this or other system components. Capacity is the combined weight for which the component is
designed to be used. Combined weight includes the user’s body weight, clothing, tools, and any objects carried. Contact
Capital Safety for more information.
3
Fall Protection Application label: A) Dorsal attachment element is for fall arrest, travel restraint, or rescue. B) Sternal
attachment element is for fall arrest (feet rst falls only, 2 ft. maximum free fall), travel restraint, or rescue. C) Frontal
attachment element is for fall arrest (feet rst falls only, 2 ft. maximum free fall), work positioning, travel restraint, or
rescue. D) Shoulder attachment elements are for rescue or entry/retrieval. E) Waist, rear attachment element is for
travel restraint. F) Hip attachment elements are for work positioning or travel restraint.
4
Compliance label: ANSI Z359 Recognizes the use of this harness only within the capacity range of: 130-310 lbs.
This product complies with the following standards only if marked with the corresponding letter code under the “Stds”
section.
5
Inspection log.

Related product manuals