Installation Instructions G5 - Revision C, September 2019
19
3M™ Drive-Thru System Model G5
Installation Instructions G5
Revision C, September 2019
1_GRT_CNL (GPIO15) Active low talk. Must use one of the GND0 or GND1 from GPIO terminal
block.
1_GRILL+ Positive phase grill monitor speaker for Lane 1
1_GRILL- Negative phase grill monitor speaker for Lane 1
1_NO Connect to relay 1 if normally open relay
1_COM Relay 1 common
ORDER POINT-2: All wires from this terminal block go to the Lane1 order point or monitor speaker
2_MIC_IN+ Positive phase microphone wire for Lane 2
2_MIC_IN- Negative phase microphone wire for Lane 2
2_GND Microphone wire shielding for Lane 2
2_SPKR_OUT+ Positive phase order point speaker for Lane 2
2_SPKR_OUT- Negative phase order point speaker for Lane 2
2_GRT_CNL (GPIO16) Active low talk. Must use one of the GND0 or GND1 from GPIO
terminal block
2_GRILL+ Positive phase grill monitor speaker for Lane 2
2_GRILL- Negative phase grill monitor speaker for Lane 2
2_NO Connect to relay 2 if normally open relay
2_COM Relay 2 common
EXT_AUDIO: 4 auxiliary, ‘line level’, audio ports. All of the wires on this terminal block go to the external audio
1_LOUT Connects to IN on external device. Allows amplification/recording of all Lane 1
audio channels (Inbound, Outbound, PAGE)
2_LOUT Connects to IN on external device. Allows amplification/recording of all Lane 2
audio channels (Inbound, Outbound, PAGE)
GND Ground
1_LIN Connects to OUT on external device. Audio can be used to record Greeter
Message for Lane 1 and to provide audio to Lane#2 Headsets/Grill Speaker.
2_LIN Connects to OUT on external device. Audio can be used to record Greeter
Message for Lane 2 and to provide audio to Lane#2 Headsets/Grill Speaker.
GND Ground
AUXILLIARY AUDIO:
L IN_A
L IN_B
LAN Network connection (crossover cable to PC or patch cable to network)
Terminal Label Definition and Connection Information
To Next Page
Loading...
