Installation Instructions G5 - Revision C, September 2019
45
3M™ Drive-Thru System Model G5
Installation Instructions G5
Revision C, September 2019
Technical Service Message
Perform the following procedure to customize the Service Screen message.
• Enter the configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select 14 Installer Setup.
• Change the value for Use Custom Tech Service Message? to Yes or No.
• If you chose Yes, enter the customer message.
Number of Basestations at this Site
The G5 Basestation Model G5B1 can function as a Single- or Dual-Lane system. Perform the following procedure to enable the Basestation
to operate as a Single- or Dual-Lane system:
• Enter the Basestation configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Change the value for 14 Installer Setup > Number of Lanes At This Site to 2.
(or to 1 if this is a Dual-Lane system but being installed to function on a Single-Lane)
• Press Enter to implement the change.
The G5 Basestation displays this option only when its Dual-Lane functionality has been activated.
The Dual-Lane functionality on the G5 Basestation Model G5B1 is not active, by default, when purchasing a new system. Dual-Lane
functionality on the G5 Basestation Model G5B1 must be activated by calling 1-800-328-0033.
S. Factory Setup (Restore Factory Defaults)
Perform the following procedure to restore all of the configuration settings to the factory default settings. This procedure should be
performed only if the current configuration and the saved installation settings are unusable.
By performing this procedure, you will reset the system to the initial configuration, making it impossible to revert to the settings that
were saved after installation.
• Enter the configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select 15 Factory Setup.
• Change the value of Restore All Factory Settings to Yes.
• The system will then reboot.
T. Create and Load Templates
You can save an entire Basestation configuration as a file on a PC and use the file as a template for other Basestations. You must use a
PC to use templates.
U. Reboot System
Perform the following procedure to cleanly power down, then power up without unplugging the system:
• Enter the configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select 17 Reboot System.
• Change the value of Power Cycle Complete System to Yes.
• Press Enter.
V. Check the Revision Levels
Perform the following procedure to view the revision levels and serial numbers of your Basestation:
• Enter the configuration mode (see "Enter Configuration Mode" on page 28) and choose 1 System Menu.
• Select 18 Revision Levels.
To Next Page
Loading...
