3M Drive-Thru G5B1 - Logging into the Basestation with a PC; Switching between Lane 1 and Lane 2

Installation Instructions G5 - Revision C, September 2019 31
3M™ Drive-Thru System Model G5
Installation Instructions G5
Revision C, September 2019
E. Logging into the Basestation with a PC
Once the Basestation is connected and configured, you can log into it from any other computer on the network and operate the station as
you would from the local interface.
To log into the Basestation:
1. Using a web browser, type in the IP address of the Basestation in the browser’s address bar, then press Enter.
2. Type in your user name and password, then press Enter. The default user name is “User1”; the default password is “1234”.
F. Switching Between Lane 1 and Lane 2
At any time, while configuring the Basestation or while on the Run Screen, you can switch the display screen to show Lane 1 or Lane 2
settings by pressing the Lane button on the keypad.
Here are some display screens that indicate a successful switch:
Figure 25.
Display Screens that are not effected by Lane change do not have the Lane number listed on the screen’s header.
For example: