To Next PageTo Next PageWhat to do if the 3M Medical Equipment warming unit alerts and the display goes dark?
If the alert sounds, the display goes dark, and the alert indicator light illuminates, it indicates a primary controller failure. Turn off and unplug the unit, discontinue its use, and discard the disposable set. The alert will continue to sound if you do not unplug the unit. Call 3M Patient Warming technical support.
What to do if the 3M Medical Equipment warming unit display reads 'Er 4' or 'Open'?
If the alpha-numeric display reads “Er 4” or “Open,” it indicates an open wire on the temperature sensor. Do not use the unit and call 3M Patient Warming technical support.
Why can't I remove the cassette from the 3M Ranger 247 Medical Equipment warming unit?
If you cannot remove the cassette from the unit, it might be too full, fluids may still be infusing, or the clamp proximal to the warming cassette might be open. Ensure the fluid is drained from the warming cassette before attempting to slide it out, confirm that fluids are no longer infusing, and verify that the clamp proximal to the warming cassette is closed. Also, if the warming unit is below the patient level, raise it above the patient level.
What to do if the 3M Ranger 247 Medical Equipment warming unit display reads 'Er 5' or 'Open'?
If the alpha-numeric display shows “Er 5” or “Open,” it indicates electrical interference. Remove the unit and call 3M Patient Warming technical support.
What to do if the 3M Ranger 247 Medical Equipment warming unit alerts soon after plugging it in?
If the unit alerts shortly after being plugged in, check the test screw on the bottom of the unit. Ensure it is completely tightened. If the screw is missing, turn off and unplug the unit. Call 3M Patient Warming technical support.
What to do if nothing illuminates on the 3M Ranger 247 Medical Equipment warming unit panel?
If nothing illuminates on the warming unit panel, first ensure the unit is turned on and properly plugged into both the power entry module and a grounded outlet. If the issue persists, call 3M Patient Warming technical support.
What to do if my 3M Ranger 247 Medical Equipment warming unit alerts after being turned off?
If the warming unit continues to sound alerts even after being turned off, it means the independent backup safety system has been activated. To stop the alerts, unplug the unit. Call 3M Patient Warming technical support.
General| Brand | 3M |
|---|---|
| Model | Ranger 247 |
| Category | Medical Equipment |
| Language | English |
Details on contacting Arizant Healthcare for technical assistance and ordering.
Critical safety information, warnings, and cautions for operating the warming unit.
Step-by-step instructions for performing the preventative maintenance on Model 245.
Procedure for testing the Model 245 unit's over-temperature alarm set points.
Procedure for testing the Model 247 unit's over-temperature alarm set points.
Solutions for common issues like no power, alarm sounds, or display problems.
Addressing advanced issues such as unit alarms on power-up or error code display.
