Page 33 of 39 RTE6701-OEM Integration Manual VC27U V1.03 DRAFT.doc
8)
Check that communications are working by entering the command 1 into the program. You should
see an output similar to this:
Choose option or Q(uit) (0-13) [0]:
1↵
P Label Part Num Ver Iss Active Conf Used Total
1 Special OCR MRTD 74-5321-01 1 0 Yes 1 155K 448K
9)
You are now ready to download to a partition, select 5 from the menu options. Check the name of the
file you need to download and enter this filename, you will see a display similar to this:
Choose option or Q(uit) (0-15) [0]: 5↵
Specify source file pathname [5231-0]: nt529104.hex
File: nt529104.hex
Partition: 1
part Number: 74-5291-04
Label: RTE (ALL MODES) OCR for MRTD
Version: 2
Issue: 2
Date created: 26-05-04 10:43
Are these values correct (Y/N/Q)? [N]: Y↵
Enter
y
to start the download. Note that the second time through some of the default values will
already be set correctly.
10)
The message
Download Commencing
will be displayed on the screen, this will be followed by a row
of dots gradually moving across the screen. Do not run or work on other programs on the PC while
downloading is in progress. Once the download is finished the message
Download completed
xxxxx bytes
will be displayed on the screen, where
xxxxx
is the number of bytes downloaded.
11)
If you want to double check use option 1 and check the partition contents have changed.
12)
Remove the power (or USB cable) from the reader.
13)
Change the jumpers back to what they were before or as required for the new firmware.
To Next Page
Loading...