PREPARE menu
Main
Auto Home
Move Axis
Disable stepper
Preheat PLA
Preheat ABS
Preheat GUM
Cooldown
• Back to main menu
• Auto home: bring all axis to zero
• Move axis: lets you move any axis using the jogwheel
• Disable steppers: this option will cutoff the power to the electric motors, letting you move axis by hand. Do note
that machine will disable steppers after 10min inactivity
• Preheat PLA/ABS/GUM: will let you preheat single parts or all of them, for the selected polymer
• Cooldown: will turn off ALL heaters
TUNE menu
Main
Speed
Nozzle
Nozzle1
Nozzle2
Nozzle3
Bed
Fan
Flow
Flow1
Flow2
Flow3
Change Filament
• Back to main menu
• Speed: setting the feedrate (printing speed). Same as turning the jogwheel when info screen is displayed
• Nozzle / Nozzle 1 / Nozzle 2 / Nozzle 3: sets nozzle temperature (do note that nozzle 3 is always referred to the
heated chamber, if installed)
• Bed: sets printing bed temperature
• Fan: sets print area cooling fan speed (0=Off 255=Max speed)
• Flow / Flow1 / Flow2 / Flow3: sets the extrusion rate as a percentage on the value requested from Gcode
• Change filament: pauses the print process, retracts some filament while parking the print ina safe corner. User
can then replace filament : pressing the jogwheel button will resume the print process. nb.: once selected this
command, please allow some seconds to complete the commands queue!!
43
To Next Page
Loading...
