PREHEAT menu (PLA/ABS/GUM)
Prepare
PLA/ABS/GUM 1
PLA/ABS/GUM 2
PLA/ABS/GUM 3
PLA/ABS/GUM ALL
PLA/ABS/GUM BED
• Prepare: back to previous menu
• 1-2-3: sets the preheating temp for desired nozzle
• ALL: preheat all the printer heaters
• BED: preheat the printing bed
MOVE AXIS menu
Prepare
Move 10mm (XY)
Move 1mm (XYZE)
Move 0.1mm (XYZE)
• Prepare: back to previous menu
• Move 10mm: can move X or Y axis at 10mm steps
• Move 1mm: can move X/Y/Z or current extruder at 1mm steps
• Move 0.1mm: can move X/Y/Z or current extruder at 0.1mm steps
CONTROL menu
Main
Temperature
Motion
Store memory
Load memory
Restore failsafe
• Back to main menu
• TEMPERATURE: thermal settings
• MOTION: movement settings
• STORE MEMORY: save current settings – will be retained in case of power off
• LOAD MEMORY: restore to previously saved settings – any unsaved change will be lost
• RESTORE FAILSAFE: recall factory settings (do a STORE MEMORY if you want to retain them after powering off)
44
To Next Page
Loading...
