3ntr A2v2 - Temperature Menu Adjustments

TEMPERATURE menu
Control
Nozzle 0
Nozzle 1
Nozzle 2
Nozzle 3
Bed
Fan
PID-P
PID-I
PID-D
PID-P H1
PID-I H1
PID-D H1
PID-P H2
PID-I H2
PID-D H2
Preheat PLA conf
Preheat ABS conf
Preheat GUM conf
• CONTROL: back to previous menu
• NOZZLE 0/1/2/3: sets the nozzle temperature (nozzle 3 refers to the heated chamber)
• BED: sets the print bed temperature
• FAN: sets print area cooling fan speed (0=Off 255=Max speed)
• PID-P/I/D H1/H2/H3 heating profile – DO NOT ALTER THOSE SETTINGS if you aren't absolutely confident with
what you're doing
• PREHEAT PLA/ABS/GUM CONF: sets preheating temperatures for desired polymer
PREHEAT PLA/ABS/GUM CONF menu
Temperature
Fan
Nozzle
Bed
Store memory
• TEMPERATURE: back to previous menu
• FAN: sets fan speed during preheating
• NOZZLE: nozzle preheating temperature
• BED: sets the printing plate preheating temperature
• STORE MEMORY: saves preheating values, to be retained when powered off
45