#3 – Part is contaminated by support material / Color separation is not sharp........................48
#4 – Part is bigger / smaller than expected.....................................................................48
#5 – Print is not completed..........................................................................................48
#6 – During homing, axis * doesn't stop and collides.........................................................48
#7 – Temperature readout is high (378°C) even if nozzle is cold.........................................49
#8 – Printed part has “falling” sides (molten)..................................................................49
#9 – Can't find files on SD card.....................................................................................49
#10 – Printed part looks squashed / print plate (Z) movement is jerky..................................49
#11 – Printed part looks shifted....................................................................................49
#12 – No USB connection, LCD is not lit.........................................................................49
#13 – Sketchy movement, axis doesn't invert direction if needed........................................50
52
To Previous Page
Loading...
