3scort TD-BLE - Sensors Main Parameters and Readings

To Next Page

To Previous Page

Sensor’s main parameters and readings

On the main screen of the sensor you can see the following parameters:

1) The serial number of the sensor

2) Version of the ﬁrmware (hereinafter - FW) installed on the sensor

3) The temperature measured by the sensor

4) The level reading - fuel level reading as a value from 1 to 1023 or from 1 to 4095 range; this is

not a reading in liters but more on that later

5) RSSI - Received Signal Strength Indicator that shows how well your smartphone receives the

data from the sensor; this parameter is NOT transmitted by the sensor but is calculated by the

device that receives the data from it;

6) Vbat or sensor’s battery charge (3.5V or more means that the battery is fully charged; 3.2V or

lower voltage means that the battery is discharged and has to be replaced);

7) The MAC address of the sensor is used to pair the sensor with the compatible trackers;

Fig. 6 Sensor’s main screen (Android)

Fig. 7 Sensor’s main screen (iOS)