Home Models Lucas No. 373 6-volt
General Export Models Lucas No. 312 6-volt
Continental Models Lucas No. 403 6-volt
French Export Models Lucas No. 379 6-volt
Parking Bulb Lucas No. 988 3-watt M.C.C.
30/24-watt prefocus (left-hand
dip).
30/24-watt prefocus (vertical
dip).
35/35-watt prefocus duplo
(vertical dip).
36/36-watt 3-pin duplo (verti-
cal dip).
Setting
The headlamp should be set so that when the machine is carrying its normal load the
driving beam is projected straight ahead and is parallel with the road surface.
Dipper switch
Every 5,000 miles the moving parts of the dipper switch should be lubricated with thin
machine oil.
HEADLAMP (ALTERNATOR MODELS)
The ignition switch (26) illustration 1, is no longer used on the above Models. A sepa-
rate ignition switch is incorporated in the right side of the headlamp body.
LUCAS STOP TAIL LAMP, MODEL 564
The correct size of bulb to be used in rear lamps is based on the cubic capacity of the
engine. The replacement bulb for this lamp is:
Lucas No. 384, 6-volt, 6/18-watt. Small bayonet cap.
LUCAS HORN, MODEL HF1441
Horns are pre-set to give their best performance and, in general, no further adjustment
is necessary.
If the horn becomes uncertain in its action, giving only a choking sound, or does not
vibrate, it does not follow that the horn has broken down—the trouble may be due to
a discharged battery, a loose connection, or short-circuit in the wiring of the horn.
In particular, ascertain that the horn-push bracket is in good electrical contact with the
handlebars.
It is also possible that the performance of a horn may be upset by its mounting becoming
loose.
Terminals
All models have the POSITIVE battery terminal connected to "EARTH".
The earth connection, for the electrical system, is connected to the frame, on top of the
seat lug tube.
Remove the twin seat for access.
Main bulb
…
…
…
84
To Next Page
Loading...
