JOYSTICK & ZOOM LEVER CALIBRATION
When using MK20RC to connect different models of PTZ cameras, the on board Joystick and
Zoom Lever may sometimes need to be recalibrated to ensure the controller accuracy and
performance. Please follow the steps below to recalibrate the Joystick and Zoom Lever.
1. Press the MENU button
Use F2 rotary knob to scroll down to CALIBRATION option and press ENTER to begin Joystick
recalibration.
2. Select CALIBRATION option
After each camera power is turned on, quick camera control switching can be achieved.
3. Follow the LCD command prompt
Follow the steps on the LCD screen to recalibrate the Joystick. First by rotating the Joystick
around to all four corners; press ENTER when finished. Then put the Joystick to its center
(neutral) position; press ENTER again when finished. This concludes the Joystick recalibration
process.
4. Select ZOOM CALIBRATION option
Under the SYSTEM Menu, use F2 rotary knob to select the ZOOM CALIBRATION option and
press ENTER.
5. Follow the LCD command prompt
Follow the steps on the LCD screen to recalibrate the Zoom Lever. First by pushing the lever
up then down to its furthest positions; press ENTER when finished. Then put the lever to its
center (neutral) position; press ENTER again when finished. This concludes the Zoom Lever
recalibration process.
To Next Page
Loading...
Need help?
General