5.5 INPUT SETUP
In this menu, you configure inputs and listening mode presets. The unit comes programmed from the factory with six
(6) inputs, but you may change this to create up to 30 inputs. MRX/AVM uses virtual inputs that give you complete
control of the name of each input you create, along with which video (HDMI) input to use, which audio input (HDMI,
digital, analog, bluetooth or streaming) to use, which speaker profile to use, and much more. You can even create
multiple inputs for the same source device. For example, a Blu-ray input configured for 7.1.4-channels and another
Blu-ray input using the same player configured for 2-channels (and no subwoofer).
Input Setup
HDMI 1
HDMI 2
HDMI 3
HDMI 4
HDMI 5
HDMI 6
HDMI 7
eARX
Streaming
HDMI 1
Bluetooth
Input Count 6
Insert Input
Delete Input
To add a new input at the end of the list, highlight “Insert Input” and press SELECT.
To delete an input, highlight “Delete Input”, press “SELECT”, highlight the input you want to delete and press
“SELECT” again.
The following settings display for each configuration:
Input Setup
Input Name HDMI 1
Video Input HDMI 1
Audio Input HDMI
Convert Analog N/A
Speaker Profile Profile 1
Anthem Room Correction N/A
Dolby Volume Off
Dolby Volume Leveler N/A
Mode Preset for Mono Sources Last Used
Mode Preset for Stereo Sources Last Used
Mode Preset for Multi-Ch Sources Last Used
Lip Sync 0 ms
Input Trim 0.0 dB
To Next Page
Loading...
