You will often find that it is difficult to accurately find the right center frequency
and demodulation is bad or not successful at all. Hence, by pressing the
right/left arrow keys, you can fine-adjust the center frequency. The used
step width is based on the filter you have previously selected. For example,
should you have chosen a 1kHz filter, fine-adjustment will take place in steps of
1kHz, and so on. The new center frequency will be shown on the large INFO dis-
play after changes.
ATTENTION: For optimal audio reproduction of signals, their levels should be
significantly higher than the noise floor.
5.0 Your first measurement / Modes
Firmware V 1.0 / © 2005-2013 by Aaronia AG, D-54597 Euscheid, www.aaronia.com
17
To Next Page
Loading...
