Aaronia SPECTRAN NF - Default Chapter; Table of Contents

Section Page
1.0 Safety instructions 5
2.0 Scope of delivery 6
3.0 LC display 7
4.0 Key layout 8
5.0 Your first measurement / Modes 9
5.1 Choosing the sensor 10
5.2 Choosing the mode of operation
11
5.3 Spectrum analysis mode 11
5.4 HOLD mode 12
5.5 The panning approach 13
5.6 Exposure limits mode 14
5.7 Audio output mode (demodulator) 16
6.0 Manual frequency selection 18
7.0 The main menu 21
7.1 Sensor (choose sensor and axis) 22
7.2 Center (center frequency) 23
7.3 Span (frequency range width) 23
7.4 fLow & fHigh (start and stop frequency) 24
7.5 RBW (bandwidth) 24
7.6 Dim
(1D, 2D or 3D measurement) 25
7.7 VBW (video filter) 25
7.8 SpTime (Sampletime) 25
7.9 Reflev (reference level) 26
7.10 Range (dynamics) 27
7.11 Atten (attenuator) 27
7.12 Demod (demodulator/audio output) 28
7.13 Detec (RMS or MinMax detector) 28
7.14 Hold (activate HOLD mode) 28
7.15 Unit (select physical unit) 29
7.16 UScale
(set scaling of physical unit) 29
7.17 MrkCnt (set number of markers) 30
7.18 MrkLvl (set starting level of markers) 30
7.19 MrkDis (marker display mode) 30
7.20 Bright (set display brightness) 31
7.21 Logger (invoke recording/data logger) 31
7.22 RunPrg (run program) 32
7.23 Setup (configuration) 32
8.0 Correct measurement 33
8.1 Noise floor 33
8.2 The 0Hz spike and the noise floor 33
Contents
Firmware V 1.0 / © 2005-2013 by Aaronia AG, D-54597 Euscheid, www..aaronia.com
3