Installation and Setup
13 41-001507-00 REV00 – 04.2014
Telco Wall Plate Installation
To mount your 6867i IP Phone on top of an existing telco wall plate:
1. Locate the wall mount insertion area on the back of the phone (above the various ports).
2. Carefully insert the Wall Mount Connector into the insertion area of your phone (ensuring the Vertical Screw Lock
Hole is facing up) and slide the Wall Mount Connector towards the right until it snaps in place.
3. Turn over your phone and locate the handset hook found in the handset cradle.
4. Using your index finger and thumb, rotate the handset hook 180° as illustrated in the figure below.
The handset hook is now in the correct position ensuring that your phone’s handset securely stays on hook when
the phone is mounted to the wall.
To Next Page
Loading...
