6.8 Tilting the stair climbing system
To drive on slopes or to climb stairs you must tilt the s-max sella, which can
be done easily by means of the climber.
1. Turn on the s-max sella by pressing the ON/OFF switch.
2. Press the UP/DOWN switch direction DOWN until the climber lift the
main wheels at least 1-2 cm off the floor (see picture).
3. Put your foot on the housing and tilt the s-max sella slightly toward
you until you feel that the s-max sella is balanced.
4. The s-max sella is balanced if you feel neither pull nor push in the
handle.
5. In order to drive on level ground, the climber must be pulled in enti
-
rely.
If you tilt the s-max sella further, or too much, the safety brakes engage and
the s-max sella can't be moved forward any more.
6.9 Operation on slopes
To drive on a slope, make sure the handle is adjusted appropriately (see
chapter 3.7.1 and 6.7). Now tilt the s-max sella slightly backwards and pull
in the climber entirely (see chapter 6.8).
6.9.1 Downhill
Drive forward to the edge of the slope. In order to slow down you need to tilt
the s-max sella a bit more, so that the safety brakes are activated.
6.9.2 Uphill
Please drive backwards up a slope. In order to slow down you need to tilt the
s-max sella a bit more, so that the safety brakes are activated.
25
s-max sella · 160 kg
To Next Page
