7 Accessories
7.1 Battery pack
The s-max sella works with batteries and is delivered with one battery pack
with charging electronics and safety latch.
If you use the s-max sella often, i.e. if there are not sufficient breaks for the
batteries to be recharged, we recommend you obtain an additional battery
pack (available as an accessory). In such case one battery pack is in use whi
-
le the other is being recharged at the same time.
F
If you do not use the s-max sella both battery packs should be con
-
nected to the charger to increase their durability (see chapter
8.3.2).
F
Please exclusively use the AAT Alber Antriebstechnik GmbH charger
to charge your battery pack.
7.1.1 Exchange the battery pack
1. Turn off the s-max sella using the ON/OFF switch.
2. Press the release button on top of the climbing unit's housing un
-
til it disengages. Now you pull out the battery pack at its handle
from its housing.
3. Push the other fully charged battery pack into its housing. This
establishes the power connection and locks the battery pack.
F
The battery pack should always be connected to the charger to ex-
tend its durability (see chapter 8.3.2).
F
Please exclusively use the AAT Alber Antriebstechnik GmbH charger
to charge your battery pack.
7.2 Voltage converter for your vehicle
We recommend the voltage converter for your vehicle, if you transport the
stairclimber s-max sella in your car. The AAT voltage converter is designed
for a 12 V electrical system. This voltage converter transforms 12 V / 24 V di
-
rect current (D.C.) into 230 V alternating current (A.C.).
The plug of the voltage converter is plugged into the cigarette lighter in
your car or into the socket of the supply system. The automatic charger’s
230 V connector is plugged into the socket of the converter.
33
s-max sella · 160 kg
To Next Page
