AAXA Technologies LED PICO + - Troubleshooting Operation and Files

40
Technical Details
THE PROJECTOR SHUTS OFF WHILE IN USE
Possible Causes Solution
Incorrect power output used For continuous operation, a USB Charger with
5V/2A output is required. Laptop USB port or
5V/1A output USB chargers does not support
continuous operation and will cause unit to
shut o󰀨 when battery is being used up.
Low battery Charge the projector until the battery is fully
charged (LED indicator on botton of unit show a
green light). Projector must be turned o󰀨 while
charging.
NO PICTURE / FILE NOT SUPPORTED
Possible Causes Solution
The video source is not properly connected or
selected.
Check the video source signal to ensure that it
is properly connected. Select the current input
source by choosing the input desired from the
main menu
Incorrect le extension / Video is encoded with
incorrect codec.
Please refer to “Specications” page to see which
le types and codex are supported. Verify that the
le was encoded properly.
Troubleshooting