FUELING AND FUEL SYSTEM / GENERAL SYSTEM ARRANGEMENT / ELECTRICAL SYSTEM OPERATION
12
•Do not ll tank to capacity. Allow for fuel expansion.
•Do not drill holes in the deck deeper than 1.27 cm (1/2"). Otherwise the
fuel tank will be perforated. Fuel leaks could occur, which if ignited may
cause serious injury or death.
DANGER
•When operating, occupants MUST AVOID standing up or sitting with
their
feet hanging over the gunwale.
•Leaking fuel is a re and explosion hazard. Inspect fuel system
regularly.
WARNING
Fuel is ammable and explosive under certain conditions.
Do not smoke or allow open ames or sparks in the vicinity.
your local dealer. Each system and its equipment were
carefully selected and designed to comply with the require-
ments settled by the ABYC and ISO standards. Also, this
equipment is certied for marine use, which guarantees
durability under the conditions of humidity and salinity of
the marine environment.
General System Arrangement
The following equipment description includes only the
elements which are installed at the factory as standard
equipment. For any additional information please contact
Electrical System Operation
The ABJET is eqquiped with a 12-volt direct current electrical
system. The positive (+) red large gauge cable is connected
between the (+) battery terminal and the battery switch. The
negative (-) yellow large gauge cable is connected to a
common post ground, where all negative wires of the boat
devices are connected. To start yor engine turn ON the battery
switch.
When the boat is in operation, the battery will be permanent-
Do not place the battery switch in the o position
while the engine is running.
CAUTION
Breakers and Fuses
Each electrical circuit has been designed to meet the
standards set in ABYC. E-11. AB inatables has made empha-
sis on the selection of the circuit protection and automatic
cutting devices.
I
N
S
P
E
C
T
S
Y
S
T
E
M
F
O
R
L
E
A
K
S
A
T
L
E
A
S
T
O
N
C
E
A
Y
E
A
R
.
WARNING
GENERAL DESCRIPTION
To Next Page
Loading...