AB Inflatables ABJET - S Ys T E M & E Q U I Pm E N T; Maintenance

35
9. Apply with a brush to BOTH surfaces, one coat of glue, as
thin as possible and making sure its spread evenly. Leave it to
dry for 15 minutes before applying the second coat. Once the
rst coat has become tacky, apply a second coat of glue to
both parts. Let dry once again for 15 minutes.
10. When the last 15 minutes have elapsed, put the two parts
together. Start by axing one side of the patch, and move
slowly to the other side by pressing the surfaces together.
This will press the air bubbles out.
11. Take the but of a screwdriver and press it over the already
glued together parch or accessory, always from the center
outwards so as to press out any trapped air bubbles. Once
glued together remove the masking tape.
12. Let the repair dry during 24 hours.
Slight Ungluing
Slight ungluing will be treated the same way as described
above. Widen slightly the unglued parts, bu and glue, as
instructed.
Large tears
For large tears, please take your inatable to an authorized
service center.
Note: In humid, wet or cold weather the glue may dry
slowly, and may remain wet/humid. It may be necessary to
use an electric hair dryer until the glue dries to tacky state.
System & equipment maintenance
Maintenance
Despite having an excellent equipment line, the moisture
and saltiness permanently present in marine environment
can aect the components and may cause failures if they
don’t receive proper maintenance.
• Regularly review the status of the fuel hose connections to
ensure there are no leaks.
• Perform regular maintenance for electrical equipment.
• Seek for a certied electrical marine technician in case of
repairs.
Automatic re extinguisher
maintenance
Monthly
• Make a general visual inspection of all aerosol generators
for
damaged or missing parts.
• Make sure that the generators are not obstructed and that
the required clearances have been kept.
Biannual
• Make a general visual inspection of all aerosol generators
for
damaged or missing parts.
MAINTENANCE & INSPECTIONS
GENERAL BOAT MAINTENANCE / SYSTEM & EQUIPMENT MAINTENANCE