94 Chapter 17 Configuration Manual Corrigo Ventilation, revision R
Alarm text
The alarm text that should be shown in the display when there is an alarm can be changed using E
tool
©
. For more information, see the E tool
©
manual.
Alarm list
The alarm text and priority columns show the factory set values.
Alarm text Pri Description
Malfunction Supply air fan
Run Error Extract Air Fan
Malfunction Extract air fan
Malfunction pump, Heating circuit
4 Run Error P1-Cooler B Malfunction pump, Cooling circuit
5 Run Error P1-Exchanger B Malfunction pump, Liquid connected
exchanger
Filter guard pressure switch activated
8 External frost guard A External Frost protection thermostat
activated
9 Deicing pressure guard - Exchanger de-icing pressure switch
activated
10 Fire alarm A Fire alarm activated
11 External switch C "External switch" activated
13 Supply Air control error B Supply air temp deviates too much from the
setpoint for too long.
14 Humidity control error - The room humidity deviates too much from
the setpoint.
15 High supply air temp B Supply air temp too high
16 Low supply air temp B Supply air temp too low
17 Supply air temp max - Maximum limiting of supply air temp active
18 Supply air temp min - Minimum limiting of supply air temp active
19 High room temp B Room temp too high during room temp
control
20 Low room temp B Room temp too low during room temp
21 High extract air temp B High extract air temp during extract air
control
22 Low extract air temp B Low extract air temp during extract air
control
23 Electric heating is overheated A Heater high temperature limit switch
24 Frost risk B Frost protection function is overriding the
control of the heater output
25 Low frostguard temp A Frost protection temperature below frost
limit value
26 Low efficiency B Heat exchanger efficiency below limit value
27 Sensor error Outdoor temp B Malfunction of connected sensor
28 Analogue de-icing - Exchanger de-icing activated by de-icing
sensor
29 Rotation guard exchanger B Exchanger rotation sentinel alarm activated