ABB 2600T-266 - Installation;start-up errors

2600T Series Pressure transmitters | OI/266/PB-EN Rev. E 89
Appendix D – Troubleshooting
sym Error HMI code Description Possible Cause Suggested Actions
Installation/start-up errors
Replace Info
Replace required – Data directions valid
M020.042
The Replace operation is required after the changing of the electronics or of the sensor
The Electronics or the Sensor have been changed but the replacement operation has not been executed
The replacement operation must be executed: - Move the SW 1 of the electronics in position 1 = Enable replace mode -Select the SW 2 the element that has been changed between new Sensor or new electronics - Power Cycle the device - Move the SW 1 of the electronics in position 0
Replace required – FE to CB not applicable
The Replace operation is required after the changing of the electronics or of the sensor
The Electronics or the Sensor has been changed and a replacement operation for a new sensor has to be executed.
The replacement operation must be executed: Only electronics data can be copied into the sensor - Move the SW 1 to Enable replace mode (1) - Select with the SW 2 to New Sensor (1) - Power Cycle the device - Move the SW 1 to Disable replace mode (0)
Replace enabled – FE to CB not applicable
The Replace operation has been attempted but with wrong direction
The Electronics or the Sensor have been changed, The replacement has been enabled but with a wrong direction (SW 2 = 0)
Change the replacement direction (if possible) - The SW 1 is already set to Enable replace mode (1) - Select with the SW 2 to New Sensor (1) - Power Cycle the device - Move the SW 1 to Disable replace mode (0)
Process errors
Pressure Overrange F104.032 An overpressure has been detected
This effect could be produced by other equipment on the process, (valves…..). Exceeding the pressure range can cause reduced accuracy or mechanical damage to the diaphragm material and may require calibration/replacement.
The compatibility of pressure transmitter model and process conditions has to be checked. A different transmitter type could be required
P-dP Out Of Limit F102.004
The measured Process Pressure value is outside the sensor limits and no longer representing the true applied process value.
The measurement range has not been correctly calculated OR an incorrect transducer model has been selected.
The compatibility of pressure transmitter model and process conditions has to be checked. Probably a different transmitter type is required.
Static Pressure Out Of Limit F100.005
The measured Static pressure is above its operational limit
The static pressure of the process exceeds the limit of the sensor. Exceeding the Static Pressure can reduce accuracy, mechanically damage the diaphragm and may require calibration/replacement. An incorrect transducer model could have been selected.
The compatibility of pressure transmitter model and process conditions has to be checked. Probably a different transmitter type is required.
Sensor Temperature Out Of Limit
S054.006
The measured sensor temperature is outside of its operational limits
The temperature of the process environment affects the pressure transmitter; Excess temperature can reduce accuracy, degrade device components and may require calibration/replacement.
The compatibility of pressure transmitter model and process conditions has to be checked. A different installation type could be required e.g. remote seals.
Max. Working Pressure Exceeded
M052.031
The Static Pressure is higher than the acceptable mechanical limit for the process connection elements.
The static pressure of the process exceeds the MWP supported by the transmitter. Exceeding the MWP can mechanically damage the process connections (flanges, pipes….) and/or be dangerous
The compatibility of process connections and material with the process has to be checked. A different installation type could be required e.g. remote seals.