Need help?Do you have a question about the ABB 2600T EN Series and is the answer not in the manual?
General| Accuracy | ±0.075% of span |
|---|---|
| Process Temperature | -40 to 85 °C (-40 to 185 °F) |
| Ambient Temperature | -40 to 85 °C (-40 to 185 °F) |
| Power Supply | 10.5 to 45 V DC |
| Housing Material | Aluminum or Stainless Steel |
| Type | Pressure Transmitter |
| Output Signal | 4-20 mA HART, PROFIBUS PA, FOUNDATION Fieldbus |
| Protection Rating | IP66, IP67 |
| Measurement Type | Absolute, gauge, differential pressure |
| Stability | ±0.1% of URL per year |
| Electrical Connection | M20x1.5, 1/2-14 NPT |
| Process Connection | 1/2" NPT, 1/4" NPT |
| Certifications | ATEX, IECEx, CSA |
| Communication Protocol | HART, PROFIBUS PA, FOUNDATION Fieldbus |
Key points to ensure safety and avoid risks when using ABB products.
Covers safety philosophy, SIL classification, and information requirements for safety systems.
Details the management of functional safety and safety planning throughout the lifecycle.
Provides warnings for installation, including hazardous areas and mechanical stresses.
Details how to make electrical connections, including terminal layouts and warnings.
Specifies operating voltage, current limits, and transmitter failure modes as per NE 43.
Explains how to enable/disable operating mode using write protect switch and HART commands.
Details methods for calibration and preparatory steps like setting links and connections.
Step-by-step guide for adjusting zero and span for gauge and absolute pressure.
Procedures for zero suppression and elevation for gauge pressure transmitters.
Steps for performing the pre-startup acceptance test to validate safety functionality.
Procedure for annual proof testing to maintain claimed Safety Integrity Level (SIL 2).
To Next Page
