Installation and maintenance guide
1ZSC000563-ACD EN, REV. A, 2019-06-25
17
4. Remove the plug (11).
G006816
5.
Put the signal cable through the cable gland (9).
CAUTION!
Make sure that the seal (8) has a
correct seal against the signal cable.
An incorrect seal will cause water to
leak into the terminal cover.
NOTE!
If the bushing is used outdoors: the
cable gland must be of
IP67 classification or better, and have a
rubber seal (8).
NOTE!
The cable gland must have
PR 16 threads.
G006820
6.
Install the cable gland (9) to the terminal
cover (5).
G006419
To Next Page
Loading...
