Need help?Do you have a question about the ABB RETA-02 and is the answer not in the manual?
Details general safety instructions for electrical work, including earthing and discharging precautions.
Describes the Modbus/TCP protocol as a simple, vendor-neutral automation communication protocol.
Explains PROFINET IO as an Ethernet-based protocol for data exchange with controllers.
Details the procedure for physically installing the RETA-02 module into the drive.
Guides through connecting the Ethernet network cable to the RETA-02 module.
Explains initial drive configuration steps to enable communication with the RETA-02.
Details methods for setting up the RETA-02 module's network configuration, including IP address.
Describes the specific configuration steps for using the Modbus/TCP protocol.
Describes the specific configuration steps for using the PROFINET IO protocol.
Details the steps for inserting and securing the RETA-02 module into the drive.
Details the parameters needed to configure the RETA-02 module and activate drive communication.
Explains various methods for configuring the module's IP address and network settings.
Details how to use DCP for PROFINET IO IP address and station name assignment.
Outlines the process of configuring the master station using a GSD file for PROFINET IO.
Details the PROFIdrive communication profile, including control and status words.
Explains the bit-coded Control Word for drive commands and Status Word for drive state.
Details the ABB Drives communication profile for controlling drives via fieldbus.
Explains the Control and Status words for the ABB Drives communication profile.
Explains Modbus/TCP register read/write operations and parameter mapping.
Describes how to read and write data to the drive's 4xxxx register area via Modbus/TCP.
Describes how RETA-02 supports PROFINET IO in Vendor and PROFIdrive modes.
Explains cyclic data exchange in Vendor mode, controlled by ABB Drives communication profile.
Explains cyclic data exchange in PROFIdrive mode using standard telegrams.
Describes the function of the Link/Activity, Network Status, and Module Status LEDs in Modbus/TCP.
Describes the function of the Link/Activity, Network Status, and Module Status LEDs in PROFINET IO.
Provides technical specifications for the RETA-02 Ethernet Adapter module.
To Next Page
General
