Electrical installation
31
Electrical installation
WARNING! Before installation, switch off the drive power supply.
Wait five minutes to ensure that the capacitor bank of the drive is
discharged. Switch off all dangerous voltages connected from
external control circuits to the inputs and outputs of the drive.
General cabling instructions
Arrange the network cable as far away from the motor cables as
possible. Avoid parallel runs. Use bushings at cable entries.
Ethernet connection
The network cable is connected to the RJ45 connector (X1) on the
RETA-02 module. Standard CAT 5 UTP and CAT 5 STP
(recommended) cables can be used. In case CAT 5 STP is used,
the cable shield is connected via rc filter to drive frame through the
module.
To Next Page
Loading...
