Quick start-up guide
21
Configuration Protocol (DCP) for assigning the IP address and
the device name. Also methods described in chapter Network
configuration can be used to set the IP address of the module.
Communication
The module is now ready to operate with Modbus/TCP protocol
according to Modbus/TCP specification 1.0 or PROFINET IO
protocol. For more detailed information on modifying the protocol
specific settings, see chapter Drive configuration.
Modbus/TCP configuration
Modbus TCP is based on data registers, which hold IO and
parameter values. See chapter Communication for register
mapping and supported function codes.
PROFINET IO configuration
Install the RETA-02 GSDML file (e.g. GSDML-V2.0-ABBDrives-
RETA02-yyyymmdd.xml, where yyyy = year, mm = month, dd =
day of the month when the file was created) and after that update
the device catalog.
Figure 2. Menu selection for installing the GSD file
To Next Page
Loading...
