ABB A135-H66 - Malfunctions When Stopping; Table 27: Malfunctions When Stopping - Runout Noises; Table 28: Malfunctions When Stopping

To Next Page

To Previous Page

Operation Manual / A130-H.. - A140-H..

8 Eliminating malfunctions / 8.4 Malfunctions when stopping

8.4 Malfunctions when stopping

Runout noises

Possible causes Remedy

Turbochar-

ger

Turbocharger contaminated Clean (see chapter Periodic maintenance work

→60)

Bearing damaged Check clearances (see chapter Measuring clear-

ance A and B). If clearances are outside the toler-

ance or if in doubt, contact an ABB Turbocharging

Service Station.

Rotor rubbing Check clearances (see chapter Radial clearances N

and R). If clearances are outside the tolerance or if

in doubt, contact an ABB Turbocharging Service

Station.

Foreign object in the tur-

bocharger

Dismantle turbocharger (see chapter Dismantling

and fitting →78). In case of damage, replace the

corresponding parts or contact an ABB Turbochar-

ging Service Station.

Table27: Malfunctions when stopping – Runout noises

Runout time too short

The runout time must be noted down as a reference. Because the runout time depends on

the oil viscosity, the runout time must always be measured at the same oil temperature.

If the runout time is significantly shorter in comparison to a previous measurement, the fol-

lowing table must be observed.