Chapter 3 – Electrical Installation
ACA 6xx Sections and ACS/ACC 6x7 (132 to 3000 kW) Frequency Converters 3-9
Power Cable Busbars
A view of power cable busbars of large ACx 600 units is shown below.
If necessary, the same screw can be used for connecting two cable
lugs (on both sides of
the busbar). Cable lugs with one or two holes
can be used.
Always use a torque wrench for tightening the busbar
connections. Note: In inverter modules R6i and R7i, only one cable lug
can be connected to a busbar screw.
40 mm
100 mm
50
To Next Page
Loading...
