ACH550 E-Clipse Bypass User’s Manual 2-33
Start-up
Start-up
Start-up
Start-Up can be performed in two ways:
• Using the Start-Up Parameter List
• Changing the parameters individually from the Full Parameter List.
Note: Run motor from drive before attempting bypass operation.
Start-up by changing the parameters from the start-up list
To change the parameters, follow these steps:
1The Default Display indicates the
Bypass Control mode.
2 Press ENTER to enter the Main Menu.
3 Select the Startup Params with the
Up/Down arrows and press ENTER.
Down
Enabled LED
Drive and Bypass
Selected/Faulted LEDs
Drive/Bypass Select Keys
Motor Run LED
OFF/Reset Key
ON/Hand Key
Enter
Up
LCD Display
Auto Key
Escape
To Next Page
Loading...
