ABB ACH550-VCR - Page 380

2-34 ACH550 E-Clipse Bypass User’s Manual
Start-up
Start-up by changing the parameters individually from the parameter list
To change the parameters, follow these steps:
4 Select the appropriate Parameter with
the Up/Down arrows and press
ENTER.
5 Press the Up/Down arrows to change
the Parameter Value.
6 Press ENTER to store the modified
value or press ESC to leave the
Parameter Edit mode.
or
7 Press ESC to return to the Main Menu,
and again to return to the. Default
Display.
1The Default Display indicates the
Bypass Control mode.
2 Press ENTER to enter the Main Menu.
3 Select the Parameter List with the Up/
Down arrows and press ENTER.
4 Select the appropriate Parameter
Group with the Up/Down arrows and
press ENTER.
5 Select the appropriate Parameter in a
group with the Up/Down arrows and
press ENTER.
6 Press the Up/Down arrows to change
the Parameter Value.
7 Press ENTER to store the modified
value or press ESC to leave the
Parameter Edit mode.
or
8 Press ESC to return to the listing of
Parameter Groups, and again to
return to the Main Menu.
9 Press ESC to return to the Default
Display from the Main Menu.
ENTER
*1601 START/STOP
1613 BP DISABLE
ENTER
ESC
*1601 START/STOP
1613 BP DISABLE
ESC
ENTER
ENTER
ENTER
ENTER
ENTER
ESC
ESC
ESC
ESC