ABB ACH550-VCR - Page 425

ACH550 E-Clipse Bypass User’s Manual 2-79
Parameters
Group 54: FBA Data In
Group 55: FBA Data Out
Group 98: Options
Group 54: FBA Data In
Code Name Resolution Range Default Description
5401
...
5410
DATA IN 1
...
DATA IN 10
1 0 = Not In Use
1 = Control Word (ABBDP)
2 = Ref 1 (ABBDP)
3 = Ref 2 (ABBDP)
4 = Status Word (ABBDP)
5 = Actual Value 1 (ABBDP)
6 = Actual Value 2 (ABBDP)
10001 - 19999 = Bypass
parameter index
+10000
— Figure module support. Specifies
addresses of parameters to be
read from the drive (IN to
network). Only for modules that
support the cyclic low scanner
function.
Group 55: FBA Data Out
Code Name Resolution Range Default Description
5501
...
5510
DATA OUT 1
...
DATA OUT10
1 0 = Not In Use
1 = Control Word (ABBDP)
2 = Ref 1 (ABBDP)
3 = Ref 2 (ABBDP)
4 = Status Word (ABBDP)
5 = Actual Value 1 (ABBDP)
6 = Actual Value 2 (ABBDP)
10001 - 19999 = Bypass
parameter index
+10000
— Figure module support. Specifies
addresses of parameters to be
read from the drive (OUT to
network). Only for modules that
support the cyclic low scanner
function.
Group 98: Options
Code Name Resolution Range Default Description
9802 COMM PROT 1 0=NOT SEL
1=STD MODBUS
2=N2
3=FLN
4=EXT FBA
5=BACNET
0 This parameter functions in place
of drive parameter 98.02 which
must be set to Modbus in E-
Clipse Bypass system. User
fieldbus is set at E-Clipse panel.