ACH550 E-Clipse Bypass User’s Manual 2-143
Embedded fieldbus
a. Points not listed are not used in this application.
b. A single value in a column means that the value is the same in English units and in SI units.
c. Point numbers that appear in brackets { } may be unbundled at the field panel.
{43} LDO RO 4
COMMAND
OFF - 1 0 [ON] [OFF]
{44} LDO RO 5
COMMAND
OFF - 1 0 [ON] [OFF]
{48} LDO RST RUN TIME 0 - - - - -
{49} LDO RESET KWH 0 - 1 0 - -
{50} LDO START ENA 1 DISABL - 1 0 [ENABLE] [DISABL]
{51} LDO START ENA 2 DISABL - 1 0 [ENABLE] [DISABL]
{52} LDO START ENA 3 DISABL - 1 0 [ENABLE] [DISABL]
{53} LDO START ENA 4 DISABL - 1 0 [ENABLE] [DISABL]
{59} LDO LOCK PANEL OPEN - 1 0 [LOCK] [UNLOCK]
{68} LDO FLN LOC CTL AUTO - 1 0 [FLN] [AUTO]
{70} LDI DI 1 ACTUAL OFF - 1 0 [ON] [OFF]
{71} LDI DI 2 ACTUAL OFF - 1 0 [ON] [OFF]
{72} LDI DI 3 ACTUAL OFF - 1 0 [ON] [OFF]
{73} LDI DI 4 ACTUAL OFF - 1 0 [ON] [OFF]
{74} LDI DI 5 ACTUAL OFF - 1 0 [ON] [OFF]
{75} LDI DI 6 ACTUAL OFF - 1 0 [ON] [OFF]
{76} LDI RO 1 ACTUAL OFF - 1 0 [ON] [OFF]
{77} LDI RO 2 ACTUAL OFF - 1 0 [ON] [OFF]
{78} LDI RO 3 ACTUAL OFF - 1 0 [ON] [OFF]
{79} LDI RO 4 ACTUAL OFF - 1 0 [ON] [OFF]
{80} LDI RO 5 ACTUAL OFF - 1 0 [ON] [OFF]
{86} LDI BYPASS ALARM OK - 1 0 [ALARM] [OK]
{88} LAI ALARM WORD 1 0 - 1 0 - -
{89} LAI ALARM WORD 2 0 - 1 0 - -
{90} LAI LAST FAULT - - 1 0 - -
{93} LDI OK.FAULTBYP OK - 1 0 [FAULT] [OK]
{94} LDO RESET FAULT NO - 1 0 [RESET] [NO]
{99} LAO ERROR STATUS - - 1 0 - -
FLN Point Database
Point
Subpoint Name
Factory
Default
Engr.
Units
Slope Intercept
On Text Off Text
# Type (SI Units)
To Next Page
Loading...
