ABB ACH580-BDR - Page 41

32 ACH580 E-Clipse bypass and packaged drive user manual
Start-up
Start-up by changing the parameters from the start-up list
To change the parameters, follow these steps:
Start-up by changing the parameters individually from the parameter list
To change the parameters, follow these steps:
1The Default Display indicates the
Bypass Control mode.
2 Press ENTER to enter the Main Menu.
3 Select the Startup Params with the
Up/Down arrows and press ENTER.
4 Select the appropriate Parameter with
the Up/Down arrows and press
ENTER.
5 Press the Up/Down arrows to change
the Parameter Value.
6 Press ENTER to store the modified
value or press ESC to leave the
Parameter Edit mode.
or
7 Press ESC to return to the Main Menu,
and again to return to the. Default
Display.
1The Default Display indicates the
Bypass Control mode.
2 Press ENTER to enter the Main Menu.
3 Select the Parameter List with the Up/
Down arrows and press ENTER.
4 Select the appropriate Parameter
Group with the Up/Down arrows and
press ENTER.
5 Select the appropriate Parameter in a
group with the Up/Down arrows and
press ENTER.
DRIVE SELECTED
BYPASS IN OFF
ENTER
*BYPASS STATUS
STARTUP PARAMS
ENTER
BYPASS STATUS
*STARTUP PARAMS
ENTER
*1601 START/STOP
1613 BP DISABLE
*1601 START/STOP
1602 PERMISSIVE
ENTER
ESC
*1601 START/STOP
1613 BP DISABLE
ESC
*1601 START/STOP
1613 BP DISABLE
DRIVE SELECTED
BYPASS IN OFF
ENTER
*BYPASS STATUS
STARTUP PARAMS
ENTER
STARTUP PARAMS
*PARAMETER LIST
ENTER
14 RELAY OUT
*16 SYSTEM CTRL
ENTER
*1601 START/STOP
1602 PERMISSIVE