Need help?Do you have a question about the ABB ACH580 Series and is the answer not in the manual?
General| Category | DC Drives |
|---|---|
| Enclosure class | IP21, IP55 |
| Mounting | Wall-mounted |
| Output voltage range | 0 V to supply voltage |
| Control method | Scalar control |
| Communication protocols | Ethernet/IP |
| Protection features | Overcurrent, Overvoltage, Undervoltage, Overtemperature, Short circuit |
| Ambient temperature range | -15 to 50 °C |
| Relative humidity | 5 to 95 % (non-condensing) |
| Cooling method | Air-cooled |
Provides essential safety guidelines for personnel installing, starting up, and maintaining the drive.
Details critical electrical safety precautions required before beginning installation, start-up, or maintenance work.
Outlines safety procedures for operating personnel to ensure safe use of the drive.
Guides on identifying the drive and preparing the installation environment, including mounting considerations.
Covers essential wiring requirements, including conduit separation and grounding for safe and effective installation.
Explains the different operating modes of the E-Clipse Bypass: Drive, Reverse Drive, and Bypass modes.
Details the functions of programmable relay outputs for system status and control signals.
Provides a comprehensive list and descriptions of parameters for bypass firmware versions, detailing actual data.
Describes how to set up serial communications for the ACH580 drive and E-Clipse bypass using embedded fieldbus.
Covers troubleshooting steps and diagnostic features for the embedded fieldbus communication.
Lists common faults, their possible causes, and recommended corrective actions for troubleshooting.
Details common warnings, their possible causes, and recommended corrective actions for advisory information.
Procedure for checking and replacing air filters in UL (NEMA) Type 12 hinged door wall mount enclosures.
Provides dimensional references and weight information for ACH580-VxR UL (NEMA) Type 1, R1-R4 Frame Sizes.
Lists standards compliance and provisions for E-Clipse bypass, identified by marks on the drive type code label.
To Next Page
