ABB ACS 300 Series - Parameter Checking for Start-up

24 ACS 300 User’s Manual
Chapter 4 - Control Connections
Figure 4-1 Control Card
The analogue input signal is selected with jumper X5 as shown in
figure 4-1 enlargement A: I = current 0(4) to 20 mA and
U = voltage 0(2) to 10 V.
X1 = Terminal block for control connections.
X2 = Plug connection to control panel.
X5 = Jumper
S1 = I/O option switch for control mode selection.
R191 = 0 ohm resistor
S1
X2
X1
R191
X5
A:
U
I