76 ACS 300 User’s Manual
Chapter 7 - Drive Parameters
PI-REF
Reference value for the PI Controller. The setting range is 0.0 to
100.0. It is not recommended to set this parameter value higher
than 0.8 x measuring scale. This value can be changed through
the control panel when in local mode. When the drive is in remote
mode this parameter is displayed only.
VERSION
Parameter Version displays the software version. For example
the software version could be CDS02B.2.
P. LOCK
Parameter Lock prevents unauthorised persons from altering the
parameters.
OPEN
The Parameter Lock is open allowing the parameter values to be
changed.
LOCKED
The Parameter Lock is active. The parameter values cannot be
changed, except parameters OUTPUT f and LOC REF.
Page 4 parameters
PAGE 4 (*P1)
Press
to change to Page 1.
Parameter set 2 parameters. These parameters are effective
when parameter PSET is set “2” and digital input 5 is active.
These parameters are similar to the respective in Pages 1 and 2.
To Next Page
Loading...
