ABB ACS2000 DFE - Page 154

154 ACS2000 DFE UM 3BHS360367 ZAB E01 REV. K
Tools
Phase module replacement kit
Image 10-14 shows the necessary parts for the
maintenance of the phase modules. The parts can
be order as a kit (standard option), or separately.
Other tools
The tools below are not included in the scope of
supply.
Depending on the frame size of the drive, the
phase module replacement kit includes the follow-
ing parts.
—
References
—
10-14 Phase module
replacement kit
—
10-14
1. 2UBA007678R0001 Module rail left and
2UBA007679R0001 Module rail right
2. 3BHB024898R0001 Module tray 2 - 3 MVA
3. 2UBA005388R0001 Module tray 4 MVA
4. 2UBA007610R0001 Support tray
5. 2UBA005486R0001 Cantilever
6. 3BHB032083R0001 Lifting hoist
7. 3BHB030813R0001 Hoisting brackets, 3 arms
8. 2UBA005859R0001 Hoisting brackets, 4 arms
1
2
3
4
5
6
7
8
10, 13 mm
225 mm
3x for frame size 2
4x for frame sizes 3 and 4
M8x13
Frame size Kit includes: Comments
1 MVA 1 Rails (1) are used to replace both inverter and rectifier modules.
Two persons - one on each side - are needed to lift a phase module off the rails.
2 MVA 1, 2, 4, 5, 6, 7 Rails (1)
are used to replace inverter modules.
Tray (2) is used to replace rectifier modules.
3 MVA 1, 2, 4, 5, 6, 8 Rails (1)
are used to replace inverter modules.
Tray (2) is used to replace rectifier modules.
4 MVA 1, 3, 4, 5, 6, 8 Rails (1)
are used to replace inverter modules.
Tray (3) is used to replace rectifier modules.