ABB ACS2000 DFE - Page 156

156 ACS2000 DFE UM 3BHS360367 ZAB E01 REV. K
5. (If using module rails) Slide the rails under the
phase module.
(If using a module tray) Anchor the tray to the
phase module. To do it:
- Holding the tray at an angle, insert the hook-
shaped ends of the tray behind the two
brackets of the phase module.
- Then lower the tray to engage the hooks
with the brackets.
6. Holding the phase module at the handles, pull it
out carefully.
7.
(INU phase modules only) Disconnect all cables
that are going into the cabinet from the Phase-
INT circuit board (1):
- Auxiliary power supply cable (2)
- Two optical fibers (3)
8.
(INU phase modules only) Detach the cable
chain on the side of the phase module (1, 2). Pull
down the end of the chain a little (3), and then
pull it into the direction of the arrow (4) to dis-
engage the chain from the mounting bracket.
CAUTION
!
To prevent the phase module from dropping on
you, make sure the rails are slid completely under
the phase module.
1
2
3
1
1
2
3
4