ABB ACS800-04 - Cable Entries; Dimensions, Weights and Noise

112 Technical data
 Cable entries
Mains, motor and brake resistor cable terminal sizes (per phase), maximum
accepted cable and tightening torques are given below.
 Dimensions, weights and noise
Hheight
W1 width of the basic unit with PE terminal (bookshelf)
W2 width with the cable connection terminal plates on the left side only (bookshelf)
(R7: width with the cable connection terminal plates on both sides is 579 mm)
(R8: width with the cable connection terminal plates on both sides is 776 mm)
D depth without fastening brackets
(R7 bookshelf: depth with fastening brackets is 516 mm)
(R8 bookshelf: depth with fastening brackets is 571 mm)
W3 width of the basic unit with PE terminal/busbar (flat)
W4 width with the cable connection terminal plates (flat)
H height without top and bottom exit busbar shrouds
Wwidth
Ddepth
* weight without top entry and bottom exit shrouds
Fram
e size
U1, V1, W1, U2, V2, W2, UDC+/R+, UDC-, R- Earthing PE
Number of holes
per phase
Max. cable Screw Tightening
torque
Screw Tightening
torque
mm
2
Nm Nm
R7 3 1×240 or
2×185
M12 50...75 M10 30...44
R8 3 3×240 M12 50...75 M10 30...44
Frame size IP00 Weight Noise
Busbars on the long side
(bookshelf)
Busbars on the short side
(flat)
HW1W2D HW3W4D
mm mm mm mm mm mm mm mm kg dB
R7 1121 334 427 473 1181 525 631 259 100 71
R8 1564 415 562 568 1596 607 779 403 200 72
Frame size IP00, with bottom exit Weight *
HWD
mm mm mm kg
R7 1126 264 471 91