ABB ACS850-04 - Installation; What this Chapter Contains

Installation
69
Installation
What this chapter contains
In this chapter, the drive module is installed in a 400 mm wide Rittal TS 8 cabinet in a
bookshelf way of mounting: The module is placed in an upright position on the
cabinet bottom with its front facing the cabinet door. The following Rittal parts and
drive module options are used in the installation examples:
Always follow the general rules given in this chapter and local laws and regulations.
ABB does not assume any liability whatsoever for any installation which breaches
local laws and/or other regulations.
Note 1: The drive module can also be installed in other than Rittal TS 8 cabinets.
Drive module standard parts
• Drive module
• Top guide plate
• Fastening bracket
• Grounding busbar
• Pedestal guide plate
• Telescopic extraction and insertion ramp
• Fastening screws in a plastic bag
• External control unit
Drive module options
Option code Qty
(pcs)
Description
+H381 1 Power cabling panels and a rubber grommet
+H383 Power cabling panels
+P905 1 Internal control unit
Rittal parts
Rittal part code Qty
(pcs)
Description
TS 8406.510 1 Enclosure without mounting plate. Includes frame, door, side and back
panels.
TS 8612.160 5 Punched section with mounting flange, outer mounting level for 600 mm
horizontal
TS 8612.140 3 Punched section with mounting flange, outer mounting level for 400 mm
horizontal
SK 3243.200 2 Air filter 323 mm × 323 mm
TS 4396.500 3 Support rails (alternative to a customer-made bottom plate)
Customer-made parts (not ABB or Rittal products)
Air baffles 6 See section Frames G1 and G2 – Air baffles on page 151 for the
dimension drawings of the air baffles required in the cabinet.
Cabinet bottom
plate (alternative to
Rittal support rails)
1 See Frames G1 and G2 – Bottom plate on page 150 for the dimension
drawing of a customer-made bottom plate.