Parameters 469
Gray Gray code. 1
92.37 SSI baud rate (Visible when an absolute encoder is selected)
Selects the baud rate for an SSI encoder.
100 kBit/s
10 kBit/s 10 kbit/s. 0
50 kBit/s 50 kbit/s. 1
100 kBit/s 100 kbit/s. 2
200 kBit/s 200 kbit/s. 3
500 kBit/s 500 kbit/s. 4
1000 kBit/s 1000 kbit/s. 5
92.40 SSI zero phase (Visible when an absolute encoder is selected)
Defines the phase angle within one sine/cosine signal period
that corresponds to the value of zero on the SSI serial link
data. The parameter is used to adjust the synchronization of
the SSI position data and the position based on sine/cosine
incremental signals. Incorrect synchronization may cause an
error of ±1 incremental period.
Note: This parameter needs to be set only when an SSI
encoder is used in initial position mode (see parameter 92.30
Serial link mode).
315-45 deg
315-45 deg 315-45 degrees. 0
45-135 deg 45-135 degrees. 1
135-225 deg 135-225 degrees. 2
225-315 deg 225-315 degrees. 3
92.45 Hiperface parity (Visible when an absolute encoder is selected)
Defines the use of parity and stop bits with a HIPERFACE
encoder.
Typically this parameter need not be set.
Odd
Odd Odd parity indication bit, one stop bit. 0
Even Even parity indication bit, one stop bit. 1
92.46 Hiperface baud rate (Visible when an absolute encoder is selected)
Defines the transfer rate of the link with a HIPERFACE
encoder.
Typically this parameter need not be set.
4800 bits/s
4800 bits/s 4800 bit/s. 0
9600 bits/s 9600 bit/s. 1
19200 bits/s 19200 bit/s. 2
38400 bits/s 38400 bit/s. 3
92.47 Hiperface node
address
(Visible when an absolute encoder is selected)
Defines the node address for a HIPERFACE encoder.
Typically this parameter need not be set.
64
0…255 HIPERFACE encoder node address. -
No. Name/Value Description Def/FbEq16
To Next Page
Loading...
