Standards and markings
Contents of this chapter
The chapter contains a list of applicable standards, a list of markings, compliance information
(European directives) and the disclaimers.
Applicable standards
Adjustable speed electrical power drive systems - Part 5-1: Safety require-
ments - Electrical, thermal and energy
EN 61800-5-1:2007
Safety of machinery - Electrical equipment of machines - Part 1: General re-
quirements
EN 60204-1: 2016
Adjustable speed electrical power drive systems - Part 3: EMC requirements
and specific test methods
EN 61800-3:2004 + A1:2012
Adjustable speed electrical power drive systems - Part 5-2: Safety require-
ments – Functional
EN 61800-5-2:2016
Safety of machinery - Functional safety of safety-related electrical, electronic
and programmable electronic control systems
EN 62061:2005 + AC:2010 +
A1:2013 + A2:2015
Safety of machinery - Safety-related parts of control systems - Part 1: General
principles for design
EN ISO 13849-1:2015
Safety of machinery - Safety-related parts of control systems - Part 2: Valida-
tion
EN ISO 13849-2:2012
Functional safety of electrical /electronic / programmable electronics safety-
related systems
IEC 61508 ed.2: 2010
Semiconductor converters - General requirements and line commutated
converters - Part 1-1: Specification on basic requirements
IEC 60146-1-1:2009,
EN 60146-1-1:2010
Insulation coordination for equipment within low-voltage systems - Part 1:
Principles, requirements and tests
IEC/EN 60664-1:2007
Degrees of protection provided by enclosures (IP code)IEC 60529:1989/A2:2013,
EN 60529:1991/A2:2013
3
Standards and markings 41
To Next Page
Loading...
