SAFETY ADVICES
2019-04-30 13
AFS670 | PRECAUTIONS AND SAFETY
NOTICE Non-observance could result in equipment damage.
Electronic equipment is sensitive to strong electromagnetic fields and may
show unexpected behavior when exposed to fields above the specified level.
→ Select an installation place with sufficient distance to equipment that pro-
duces strong electromagnetic fields (e.g. large transformers, power rectifi-
ers, generators, electrical machines, railways etc.).
NOTICE Non-observance could result in equipment damage.
The equipment has to be installed according to the instructions given in the
Installation Instruction provided in the user documentation.
→ Refer to [EN-1KHW028954] User Manual “Installation AFS670 Version 2.0”
.
→ The equipment has to be commissioned according to the instructions
given in the user documentation.
NOTICE Non-observance could result in equipment damage.
When switching off the power supply data transmission will be interrupted.
→ If possible postpone maintenance to periods with very little traffic.
NOTICE Non-observance could result in equipment damage.
When the equipment is brought from a cold to a warm environment, this may
lead to condensation. Operation of the equipment during condensation is not
permitted.
→ Equipment with condensation must be dried before taking it into opera-
tion.
NOTICE Non-observance could result in equipment damage.
In case of a repair only original spare parts may be used. Other spare parts are
only permitted if this does not affect the safety of the equipment.
NOTICE Non-observance could result in equipment damage.
Excessive bending and ignoring the minimum bending radius damages opti-
cal fibers.
→ Do not bend or press optical fibers.
→ Always keep at least the minimum bending radius.
→ Special optical fibers allow a bending radius of 15 mm.
NOTICE Non-observance could result in equipment damage.
In order to preserve the specified EMC characteristics of the equipment it is
essential to adhere to the following rules:
→ Do not modify the ferrite filters provided with the cables.
→ Ensure that all 3
rd
party equipment which is installed near to the equip-
ment is compatible with the EMC and safety standards.
To Next Page
Loading...
